Effect of lactose standardization of milk using low-concentration factor ultrafiltration: Effect of reducing the lactose-to-casein ratio on the properties of milled-curd Cheddar cheese.

The pH of cheese is determined by the amount of lactose fermented and the buffering capacity of the cheese. The buffering capacity of cheese is largely determined by the protein contents of milk and cheese and the amount of insoluble calcium phosphate in the curd, which is related to the rate of acidification. The objective of this study was to standardize both the lactose and casein contents of milk to better control final pH and prevent the development of excessive acidity in Cheddar cheese. This approach involved the use of low-concentration factor ultrafiltration of milk to increase the casein content (∼5%), followed by the addition of water, ultrafiltration permeate, or both to the retentate to adjust the lactose content. We evaluated milks with 4 different lactose-to-casein ratios (L:CN): 1.8 (control milk), 1.4, 1.1, and 0.9. All cheesemilks had similar total casein (2.3%) and fat (3.4%) contents. These milks were used to make milled-curd Cheddar cheese, and we evaluated cheese composition, texture, functionality, and sensory properties over 9 mo of ripening. Cheeses made from milks with varying levels of L:CN had similar moisture, protein, fat, and salt contents, due to slight modifications during manufacture (i.e., cutting the gel at a smaller size than control) as well as control of acid development at critical steps (i.e., cutting the gel, whey drainage, salting). As expected, decreasing the L:CN led to cheeses with lower lactic acid, residual lactose, and insoluble Ca contents, as well as a substantial pH increase during cheese ripening in cheeses. The L:CN ratio had no significant effect on the levels of primary and secondary proteolysis. Texture profile analysis showed no significant differences in hardness values during ripening. Maximum loss tangent, an index of cheese meltability, was lower until 45 d for the L:CN 1.4 and 0.9 treatments, but after 45 d, all reduced L:CN cheeses had higher maximum loss tangent values than the control cheese (L:CN 1.8). Sensory analyses showed that cheeses made from milks with reduced L:CN contents had lower acidity, sourness, sulfury notes, and chewdown cohesiveness. Standardization of milk to a specific L:CN ratio, while maintaining a constant casein level in the milk, would allow Cheddar cheese manufacturers to have tighter control of pH and acidity.

Comparison of milk produced by cows cloned by nuclear transfer with milk from non-cloned cows.

Cloning technologies, including embryo splitting and nuclear transfer, were introduced into dairy cattle breeding in the early 1980s. With the recent worldwide attention on the cloning of sheep ("Dolly") and cows ("Gene"), the potential food safety concerns for food products derived from cloned animals needs to be addressed. There has been no study of the composition of milk produced by cloned cows. In this preliminary study, we evaluated the composition of milk from 15 lactating non-embryonic cell cloned cows and six non-cloned lactating cows over a single season. The cloned cows came from five unique genetic lines and three distinct breeds. Milk samples were analyzed for total solids, fat, fatty acid profile, lactose, protein and compared to non-cloned and literature values. Gross chemical composition of milk from cloned cows was similar to that of the non-cloned cows and literature values. Our results lead us to conclude that there are no obvious differences in milk composition produced from cloned cows compared to non-cloned cows.